Electrolytic grade, high conductivity Copper Busbar having current density of 1.6 Amp/sq.mm are Electrolytic E91E grade Aluminium Busbars having current density of 1.0 amp/sq.mm are used in our panels. The Busbars shall be properly covered with Heat shrinkable PVC sleeves and duly colour coded. Necessary FRP supports are also given for Robust construction & to withstand Short circuit conditions.
All the doors, cut-outs for cable entry plates etc. shall have best quality synthetic rubber gaskets without any discontinuity to make the panel completely dust, damp & vermin proof. Necessary pretreatment on the surface of the panel board is carried out prior to powder coating i.e. Degreasing, Derusting, Phosphating and passivation to have a count of 8-10 micron phosphate coat.This is a nine tank hot phosphating process. The panel shall be finished with oven baked Powder coating to shade no. RAL7032.
PRODUCT RANGE
Power Control Centre
Motor Control Centre
Power Distribution Boards
Automatic Power Factor Controller
33KV Relay Control Panel
Automatic Change Over Panels
Auto-mains failure Panels
Furnace Control Desks
Distribution Boards
Control Boards
Synchronizing Control Panel
D.G. Set Main Control Panel
L.T. Bus Duct System
